Conventional Ammo Chart

Ammo and Frame Sizes
The following table is for a Junker to build conventional ammo with the Ammo power. Ammo is made in batches, and the frame size of the batch is equal to the ammo size times the number of rounds in the batch. Check out the Frame Sizes page for more information about that.

Ammo Stability
Ammo makes Stability rolls in batches. Check stability on the batch the first time it is fired each day. A failure indicates instability for the entire batch. The requirements to make batches of 50 are listed on the table below. Remember that base Stability is 16, +2 for each raise on the construction roll.

Components
Under the Chem/Structural column, the listed amounts are for both. So, if a batch of 50 is listed as 3 under that column, it takes 3 chemical and 3 structural components. Chemical components cost about $7 each and structural components cost about $2 each. These components can usually be bought in Junkyard but can also be scrounged up.

Power Required: Ammo
TN: 5 + Frame size of the batch
Electric: 10%
Structural: 10%

Caliber Ammo Size Frame Size (50 Rounds) Chem/Structural (50 rounds) TN (50 rounds)
.22 0.1 1 1 6
.38, 9mm CL 0.2 2 1 7
9mm, 10mm, .45 0.3 2 2 7
.357/.44 Mag, .50 P 0.4 3 2 8
.45 gyrojet 0.5 3 3 8
5.56, 10mm CL 0.6 3 3 8
.30, .30-06, 7.62 0.8 4 4 9
12 gauge 0.9 4 5 9
12mm CL 1.2 5 6 10
.50 MG 2 6 10 11

Back to Junker Items

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License